另一安裝方法 (Another Installation Method)：

如因空間限制或其他原因而無法按照基本步驟安裝邊接位時，可以從 旁邊連接，方法如下：

1. 按照基本步驟的、第二及第三步。

2. 將聯接駁頭拆下，然后將四條母線槽臨時固定，其間距與安裝尺寸相等。

3. 從側面將聯接駁頭壓入。

4. 檢查此時連接位狀態，應于完成基本步驟第四點后無異。

5. 按照基本步驟第五點開始繼續進行安裝。

If it is not possible to install the edge connector according to the basic steps due to space limitations or other reasons, you can connect it from the side as follows:

1. Follow the first, second, and third steps of the basic procedure.

2. Remove the connecting connector and temporarily fix the four bus ducts to ensure their spacing and installation dimensions equal.

3. Press the connecting connector into the side.

4. Check the status of the connection bit at this time, which should be no different after completing the fourth point of the basic steps.

5. Follow the basic steps from point five to continue the installation.